Instruction Manual - Sierra Instruments

More documents

Recommendations

Info

Sierra Instruments Instruction ManualSmartTrak ® 100 SeriesUsing the SmartTrak SoftwareA. Upper Section of Software WindowAcross the upper half of the SmartTrak Software window you will see 3 yellowboxes. These are titled: Flow Setpoint (flow controllers only. Will show zero for meters) Full ScaleThese boxes display the current operating conditions of your SmartTrak instrument. Ifyou have the Pilot Module, these boxes on the upper half of the software screen areidentical to the Upper Level Screens on the Pilot Module discussed in Chapter 4. Thefeatures of these boxes are described below.56
Sierra Instruments Instruction ManualSmartTrak ® 100 SeriesFlowThe box displays the mass flow rate, the engineering units, the gas choice and theanalog output choice.SetpointIf you have a Mass Flow Meter, this box is zero (as shown above). The Setpoint boxdisplays the current setpoint given to the flow controller, the engineering units, thesource of the setpoint signal, the current valve state (open, closed or purge) and the dacvalues for the valve (for Sierra troubleshooting only).CAUTION: If this box does not show Pilot Module/RS-232 on the first line,you will not be able to give the controller a setpoint command from yourcomputer. This is because you SmartTrak is expecting an analog setpoint atthe 15-pin mini- D-connector. To supply a setpoint from your computer, see“Change Setpoint Source” on page 5-13.57
Page 1 and 2:
Sierra Instruments Instruction Manu
Page 3 and 4:
Sierra Instruments Instruction Manu
Page 5 and 6: Sierra Instruments Instruction Manu
Page 13: Sierra Instruments Instruction Manu
Page 22 and 23: ATP: 1Fiscal Year: 2012STIP for FY
Page 92 and 93: Sierra Instruction Manual SmartTrak
show all

Instruction Manual - Sierra Instruments

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?