Instruction Manual - Sierra Instruments

Sierra Instruments Instruction ManualSmartTrak ® 100 SeriesFrom this screen you can change the zero flow bridge differential value to matchthe zero flow conditions of your application. Mount (or place) the instrument whereit is intended to be used, minding orientation, tilt, etc.; The accuracy of this functionis dictated on how close to operating conditions the unit is when the meter iszeroed. The display will show:Zero MeterConfirm zero flowThen press enterOnce you push enter, the unit will monitor the sensor bridge differential value. Thedisplay will show:Zero MeterConfirm zero flowNew ZeroUpon pressing the enter key again, the unit will record the bridge differential valueto the zero flow condition, leaving you with a freshly “zeroed” instrument! You canmake additional changes by using the left and right arrow keys to move to otherLower Level Screens. You may also choose to press the escape key to return to theUpper Level Screens.Change Password ScreenIf you are already in the Lower Level Screens, push the right or left arrow until youreach the Change Password screen. To get to this screen at any time: PressEscape—Press Enter—enter password and Press Enter. Then, press the Right orLeft arrow until you reach this screen.From this screen you can change the instrument password from the factory defaultto any four-digit password of your choice. The display will show the factory defaultpassword of four zero’s: “0000”. The display will show:Change Password0000To make a change, press the enter key. The first digit will begin to blink. Use theup and down arrows to modify this digit or the left and right arrows to chooseanother digit. When you are satisfied, press enter. The display will show:Change Password000046