Instruction Manual - Sierra Instruments

More documents

Recommendations

Info

Sierra Instruments Instruction ManualSmartTrak ® 100 SeriesTo perform this zero procedure, you must make sure that the actual flow is zero.Attempting to zero the meter or controller while there is a flow condition will causean offset. Note: This MUST be done using the appropriate gas as selected.Caution: do not perform auto zero when there is no gas present in the meter and orthe gas is FLOWING.Default zero:This will set the zero value back to factory conditions. Use this in order to recoverfrom a mistaken entry.Span:This allows the user to enter an offset to the span to adjust the meter outputs tomatch another device or field conditions. The span is a MULITPLIER and willmultiply all outputs by the entered amount.64
Sierra Instruments Instruction ManualSmartTrak ® 100 SeriesFor example, the meter reads 98. The desired reading is 100. A span value of 1.02will adjust the meter output to read 100.Caution: this number should not be adjusted beyond 0.8 to 1.2.Change full scale:This setting allows you to change the full scale of your instrumentThe instrument will display its current full-scale value. If your instrument is new orthis value has never been modified, the value displayed will be 100% of themaximum flow rate your SmartTrak can measure or control without factory recalibration.This is the number listed here:65
Page 1 and 2:
Sierra Instruments Instruction Manu
Page 3 and 4:
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13: Sierra Instruments Instruction Manu
Page 16 and 17: Sierra Instruments Instruction Manu
Page 22 and 23: ATP: 1Fiscal Year: 2012STIP for FY
Page 92 and 93: Sierra Instruction Manual SmartTrak
show all

Instruction Manual - Sierra Instruments

Create successful ePaper yourself

Delete template?

Save as template?