Installation Instructions for a âPairâ of gates...

More documents

Recommendations

Info

4 - TROUBLESHOOTING GUIDEA multimeter will be neededPROBLEMGATE WILL NOT RESPONDWHEN GIVEN A COMMANDSOLUTION1. CHECK POWER SUPPLY TO THECONTROL PANEL.2. CHECK CONTROL PANEL FUSES.3. CHECK HARD WIRE LINK FITTEDBETWEEN TERMINALS 1 & 2.4. CHECK THAT CAPACITORS AREFITTED AND WIRED CORRECTLY.GATES ARE OPEN BUTWILL NOT CLOSE ANDGREEN LED IS FLASHING1. CHECK SAFETY BEAMS ARE WIREDCORRECTLY. (IF MORE THAN ONESET OF BEAMS ARE FITTED THEYMUST BE WIRED IN SERIES.)2. CHECK THAT THERE IS POWERGOING TO THE BEAMS, IF NOTRESTORE POWER.3. IF SAFETY BEAMS ARE NOT FITTEDENSURE THAT A HARD WIRE LINK ISFITTED BETWEEN TERMINALS 2 & C14. REMOVE SAFETY BEAM WIRES 2 &C1 FROM CONTROL PANEL ANDCHECK IF YOU HAVE A NORMALLYCLOSED CIRCUIT COMING FROMTHE BEAMS.WHEN COMMISSIONING GATEAUTOMATICALLY OPENS BUTDOES NOT AUTOMATICALLYCLOSE1. MOTOR WIRES ARE WRONG WAYROUND. CHECK AND PROVE MOTORDIRECTION BY MOMENTORIALLYPULSING TERMINALS 2 & 3. THEGATE SHOULD OPEN UP. TURNAUTOMATIC CLOSING OFF (DIPSWITCH 2) UNTIL MOTORDIRECTION HAS BEEN PROVED.19
PROBLEMGATES WILL NOT RESPOND TOREMOTE CONTROLCOMMANDSOLUTION1. AF FREQUENCY CARD NOT FITTED TOCONTROL PANEL.2. REMOTE CONTROL HAS NOT BEENPROGRAMMED INTO THE CONTROLPANEL.3. REMOTE CONTROL HAS THE WRONGCODE SETTING.4. “OPERATOR PRESENT” HAS NOT BEENSELECTED TO DEACTIVATE RADIOREMOTE CONTROLS (DIPSWITCH 1).5. WRONG FREQUENCY CARD FITTEDFOR THE REMOTE CONTROL.IF THE PROBLEM IS STILL APPARENT CONTACT THE CAMETECHNICAL HELPLINE:0115 921 0430THIS INSTALLATION WAS COMPLETED BY:.........................................................................NAME..............................................................ADDRESS...................................................................................................................................................................................................................................................................................TEL........................ MOBILE............................DATE OF INSTALLATION................................20
Page 4 and 5: STAGE 1CIVIL & MECHANICAL SECTION1.
Page 6 and 7: 1.4 - Installing the MotorsINSERT T
Page 8 and 9: END OF INSTALLATIONSTAGE 1BEFORE ST
Page 10 and 11: 2.2 - Wiring the MotorsTHE FROG MOT
Page 12 and 13: 2.5 - Wiring in the Tuned AntennaAN
Page 15 and 16: ONOFF1 2 35. SELECT DIPSWITCHES 1 &
Page 17 and 18: 3.4 - Automatic Close & Activating
Page 19: END OF INSTALLATIONSTAGE 3PLEASE CH
Page 23 and 24: 5.4 - Motor Torque SettingsSEE ALSO
Page 25 and 26: Other functions available:Automatic
Page 27 and 28: 5.7 - Control Panel AdjustmentsTrim
Page 29 and 30: 5.9 - Re-Handing the Frog MotorsCEN

Installation Instructions for a âPairâ of gates...

Create successful ePaper yourself

Delete template?

Save as template?

Installation Instructions for a âPairâ of gates...