Installation Instructions for a “Pair” of gates...

1.2 - Basic Cable LayoutTHIS DIAGRAM DETAILS THE BASIC CABLE LAYOUT FOR A PAIR OF MOTORS.THE POWER SUPPLY TO THE CONTROL PANEL SHOULD BE LIVE AND PROTECTED INACCORDANCE WITH THE 16TH EDITION ELECTRICAL REGULATIONS. THE SUPPLY SHOULDBE RATED AT A MINIMUM OF 6 AMPS. WHEN INSTALLING WIRES OUTDOORS THE CABLEAPPROACH TO ALL DEVICES MUST BE FROM BELOW TO CREATE A “DRIP-LOOP” ANDTHEREBY AVOID UNNECCESSARY WATER INGRESS.CONTROL PANELJOINT BOXJOINT BOXFROG UNDERGROUNDCASING240V A.C.3 CORE SWA 1.5mmMOTOR CABLEIN DUCTING3 CORE SWA 1.5mm1.3 - Low Voltage Cable LayoutTHIS DIAGRAM DETAILS THE BASIC CABLE LAYOUT FOR A PAIR OF MOTORS.THE POWER SUPPLY TO THE CONTROL PANEL SHOULD BE LIVE AND PROTECTED INACCORDANCE WITH THE 16TH EDITION ELECTRICAL REGULATIONS. THE SUPPLY SHOULDBE RATED AT A MINIMUM OF 6 AMPS. WHEN INSTALLING WIRES OUTDOORS THE CABLEAPPROACH TO ALL DEVICES MUST BE FROM BELOW TO CREATE A “DRIP-LOOP” ANDTHEREBY AVOID UNNECCESSARY WATER INGRESS.TUNEDANTENNACOAX CABLEDOC E SAFETYBEAM8 CORE 0.2mm STRANDED TOALL SAFETY BEAMS4