Installation Instructions for a âPairâ of gates...

More documents

Recommendations

Info

5.6 - ZA4 Wiring DiagramTerminals 1 and 2, 2 and C1 are normally closed circuits and ifthey are not used they must be linkedL1 L2 U V W X Y E1 10 11 1 2 3 5 7 C1230V A/CM1Single-Phase motorM2Co-axial cableSingle-Phase motor with leaf delayon closing cycle11 TX10RX1110CNCSafety beams which are connected to obtain Re-openingDuring the closing cycle25
5.7 - Control Panel AdjustmentsTrimmer T.L - Adjustment of operating time from a minimum of 0 seconds to amaximum of 120 seconds N.B. it is advised to let the motors run on for between 6and 8 seconds after the last gate has fully close.Trimmer T.C.A - Adjustment of automatic closing time from a minimum of 1 to amaximum of 120 seconds.Trimmer T.R.2.M - Partial opening time adjustment and delay in closing of thesecond motor leaf delay from a minimum of 0 seconds to a maximum of 20 seconds.ZA4T.LT.C.AT.R.M2TRIMMERSADJUSTMENT26
Page 4 and 5: STAGE 1CIVIL & MECHANICAL SECTION1.
Page 6 and 7: 1.4 - Installing the MotorsINSERT T
Page 8 and 9: END OF INSTALLATIONSTAGE 1BEFORE ST
Page 10 and 11: 2.2 - Wiring the MotorsTHE FROG MOT
Page 12 and 13: 2.5 - Wiring in the Tuned AntennaAN
Page 15 and 16: ONOFF1 2 35. SELECT DIPSWITCHES 1 &
Page 17 and 18: 3.4 - Automatic Close & Activating
Page 19 and 20: END OF INSTALLATIONSTAGE 3PLEASE CH
Page 21 and 22: PROBLEMGATES WILL NOT RESPOND TOREM
Page 23 and 24: 5.4 - Motor Torque SettingsSEE ALSO
Page 25: Other functions available:Automatic
Page 29 and 30: 5.9 - Re-Handing the Frog MotorsCEN

Installation Instructions for a âPairâ of gates...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Installation Instructions for a âPairâ of gates...