Installation Instructions for a âPairâ of gates...

More documents

Recommendations

Info

END OF INSTALLATIONSTAGE 1BEFORE STARTING STAGE 2 - Wiring & ElectricalPLEASE CHECK THAT YOU HAVE CORRECTLY:RefPage1. INSTALLED THE FOUNDATION CASING 1.1 32. PREPARED THE CABLING CORRECTLY 1.2 41.3 43. INSTALLED THE MOTORS CORRECTLY 1.4 54. HUNG THE GATES CORRECTLY 1.5 55. CHECKED THE MANUAL RELEASESYSTEM 1.6 6NOW STAGE 1 IS FULLY COMPLETED YOU ARE READY TOBEGIN STAGE 2 OF YOUR FROG AUTOMATION KITINSTALLATION7
STAGE 2 - WIRING & ELECTRICAL2.1 - Fitting the Control Panel in the CasingSecurely fasten the control panel PCB to the casingwith the screws supplied.Screw positioning holesFastening screwsGreen connector pointScrewsPlug the green connector from the trans<strong>for</strong>mer tothe PCB ensuring that it connects the correct way.NB FROG Series Motors: connect the black wirescoming out <strong>of</strong> the board to one capacitor and thered wires to the other.8
Page 4 and 5: STAGE 1CIVIL & MECHANICAL SECTION1.
Page 6 and 7: 1.4 - Installing the MotorsINSERT T
Page 10 and 11: 2.2 - Wiring the MotorsTHE FROG MOT
Page 12 and 13: 2.5 - Wiring in the Tuned AntennaAN
Page 15 and 16: ONOFF1 2 35. SELECT DIPSWITCHES 1 &
Page 17 and 18: 3.4 - Automatic Close & Activating
Page 19 and 20: END OF INSTALLATIONSTAGE 3PLEASE CH
Page 21 and 22: PROBLEMGATES WILL NOT RESPOND TOREM
Page 23 and 24: 5.4 - Motor Torque SettingsSEE ALSO
Page 25 and 26: Other functions available:Automatic
Page 27 and 28: 5.7 - Control Panel AdjustmentsTrim
Page 29 and 30: 5.9 - Re-Handing the Frog MotorsCEN

Installation Instructions for a âPairâ of gates...

Create successful ePaper yourself

Delete template?

Save as template?

Installation Instructions for a âPairâ of gates...