Installation Instructions for a “Pair” of gates...

5.9 - Re-Handing the Frog MotorsCENTRE STOPRIGHT90° 90°LEFTON RECEIPT YOUR FROG MOTORS WILL HAVE BEEN SETUP FOR YOU AS APAIR I.E LEFT HAND AND RIGHT HAND BUT SHOULD YOU NEED TO RE-HANDTHESE MOTORS THE FOLLOWING INSTRUCTIONS WILL SHOW YOU HOW.SCREW THE M10 X 100MM BOLT (A) AND THE M10 NUT (B) INTO THEMOTOR TRANSMISSION ARM AS SHOWN IN FIGURE ABOVE. FOR R/HMOTOR INSTALLATION AND FOR L/H MOTOR INSTALLATION SEE FIGUREABOVE.ENSURE THAT THE MOTOR IS CORRECTLY FASTENED INTO THE CASINGWITH THE NUTS AND WASHERS PROVIDED. INSERT THE LIMIT ARM (C)BETWEEN THE MOTOR TRANSMISSION ARM AND THE FROG SHOE. GIVE THEGATE A COMMAND TO OPEN, WHEN THE GATE COMES TO THE OPEN POSI-TION AND THEN ADJUST THE SCREW (A).CLOSE THE GATES SO THAT SCREW (A) MEETS THE LINK ARM. THEN OPENTHE GATE AND ADJUST (A) ACCORDINGLY. DURING ADJUSTMENT ALLOW THEGATE TO PUT ADEQUATE PRESSURE ONTO THE CENTRE STOP BUTALLOWING THE GATE TO BE RE-LOCKED ONTO THE SHOE AFTER MANUALLYRELEASING THE GATE.WHEN ADJUSTMENT IS FINISHED FASTEN NUT (B).28