Installation Instructions for a âPairâ of gates...

More documents

Recommendations

Info

5.4 - Motor Torque SettingsDescription of Control Panel:Micro-processor controlled electrical cabinet powered by 230V (a/c) at50-60Hz, single phase. Designed for control of CAME (ATI/FERNI/FROG), for hingedgates, hinged industrial doors. Designed and built entirely by CAME to meetUNI8612 safety standards at an IP 54 level of protection. Housing made of ABS isequipped with vents to provide internal air circulation. Guaranteed for 3 years, unlesstampered with. This control panel is powered 230V a.c across terminals L1 and L2,and isprotected by a 5A fuse on the main power line. Control systems are powered by lowvoltage and protected by a 2A fuse. The accessories total wattage (24V) must notexceed 20W.Safety:SAFETY BEAMS CAN BE CONNECTED TO OBTAIN:Re-Opening:During closing (2-C1), if the beam is broken while the gate isclosing, they will reverse the direction of movement until the gate iscompletely open and will stay open until the obstacle is removed.Total Stop: (1-2) Creates immediate stop of gate movement without automaticclosing: (a pushbutton or radio remote control must beactuated to resume movement).N.BIF A NORMALLY CLOSED SAFETY CIRCUIT(2-C1, 1-2) IS OPENED, THE L.E.D WILLFLASH TO INDICATE THE FACT THAT THE BEAM ISBROKEN.Accessories that can be Connected to this Unit:“Gate in Motion” Lamp:The lamp that lights the manoeuvering zone:it remains lit from the the moment the gate begins to open until they are completelyclosed (including the time required for the automatic closure).When automatic closure is not enabled, the lamp remains lit only during movement(E-E3).23
Other functions available:Automatic closing:The automatic closing timer is automatically activated at theend of the opening cycle. The pre-set, adjustable automaticclosing time is automatically interrupted by the activation ofany safety system, and is deactivated after a STOPcommand or in case of power failure.“Operator present” function:Gate operates only when the pushbutton is held down (theradio control system is deactivated)1 CONTROL PANEL1 FREQUENCY CARD2 UNDERGROUND FOUNDATIONCASINGS WITH PIVOT ARMS.2 UNDERGROUNDGATE MOTORS1 PAIR SAFETY BEAMS2 REMOTE CONTROLTRANSMITTERSTUNED ANTENNA24
Page 4 and 5: STAGE 1CIVIL & MECHANICAL SECTION1.
Page 6 and 7: 1.4 - Installing the MotorsINSERT T
Page 8 and 9: END OF INSTALLATIONSTAGE 1BEFORE ST
Page 10 and 11: 2.2 - Wiring the MotorsTHE FROG MOT
Page 12 and 13: 2.5 - Wiring in the Tuned AntennaAN
Page 15 and 16: ONOFF1 2 35. SELECT DIPSWITCHES 1 &
Page 17 and 18: 3.4 - Automatic Close & Activating
Page 19 and 20: END OF INSTALLATIONSTAGE 3PLEASE CH
Page 21 and 22: PROBLEMGATES WILL NOT RESPOND TOREM
Page 23: 5.4 - Motor Torque SettingsSEE ALSO
Page 27 and 28: 5.7 - Control Panel AdjustmentsTrim
Page 29 and 30: 5.9 - Re-Handing the Frog MotorsCEN

Installation Instructions for a âPairâ of gates...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

Installation Instructions for a âPairâ of gates...