PENTAGRAM Cerberus [P 6367] Installation and Operation Manual
PENTAGRAM Cerberus [P 6367] Installation and Operation Manual
PENTAGRAM Cerberus [P 6367] Installation and Operation Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>PENTAGRAM</strong> <strong>Cerberus</strong> [P <strong>6367</strong>]Finishing the wizardClick Apply to save the settings.The Router is rebooting to bring the configuration into effect, please DO NOT power off it.Advanced Settings [3G Router, WISP or Wireless Router Mode]LAN Settings [3G Router, WISP or Wireless Router Mode]This section mainly describes how to configure the TCP/IP parameters of local network.In 3G Router mode, WISP mode, Wireless Router mode, please configure the LAN portparameters as the diagram below.NOTE:In Wireless Router mode, you can only configure the device by using the wirelessaccess way.MAC Address: It displays the router’s LAN MAC address, which can not be changed.IP Address: The Router’s LAN IP address (not your PC’s IP address). The default value is192.168.1.100 .Subnet Mask: The Router’s LAN subnet mask. The default value is 255.255.255.0 .NOTE:If you change the IP, you need to use the new one to log in to the Web interface.19