z/OS V1R9.0 TSO/E Command Reference

LOADGO CommandFILL(fill_byte)specifies to the binder the byte value to be used to initialize uninitilalizedstorage areas in the loaded program. This must be two hexadecimal digits orthe word NONE.HOBSET(NO | YES)NOspecifies that the binder NOT set the high-order bit (HOB) in V-type adconsaccording to the AMODE of the target entry point. NO is the default.YESspecifies that the binder set the high-order bit (HOB) in V-type adconsaccording to the AMODE of the target entry point.LINECTspecifies the number of lines (including heading and blank lines) contained oneach page of the binder listing. The valid range is 24-200 and 0. Zero indicatesa single, indefinitely long page, and values of 1-23 are forced to 24; however,there are always page ejects at the beginning of the binder listing and the startof the map, cross reference (XREF), and summary reports. LINECT defaults to60 lines.LIST | NOLIST | LIST(OFF | STMT | SUMMARY | NOIMPORT| ALL)allows you to control the type of information included in the SYSPRINT data.LIST is valid for both the linkage editor and the binder. LIST, with no value, isequivalent to LIST (SUMMARY), and NOLIST is equivalent to LIST(OFF).OFFindicates that only messages will be printed. In a batch environment,LIST(OFF) is equivalent to NOLIST.STMTindicates that messages and control statements to be printed. In a batchenvironment, LIST(STMT) is equivalent to LIST.NOIMPORTproduces the same output as SUMMARY except without IMPORT controlstatements.SUMMARYindicates that messages, control statements, and a load summary report(including processing options and module attributes) are to be printed.ALLindicates that all input activity (whether initiated by binder service calls orcontrol statements) and the load or save summary be logged.PLILIBspecifies the partitioned data set named SYS1.PL1LIB is to be searched tolocate external symbols referred to by the module being processed.PLIBASEspecifies the partitioned data set named SYS1.PLIBASE is to be searched tolocate external symbols referred to by the module being processed.PLICMIXspecifies the partitioned data set named SYS1.PLICMIX is to be searched tolocate external symbols referred to by the module being processed.FORTLIBspecifies the partitioned data set named SYS1.FORTLIB is to be searched tolocate external symbols referred to by the module being processed.Chapter 1. TSO/E commands and subcommands 187