z/OS V1R9.0 TSO/E Command Reference

TEST—DELETEExample 8Operation: Copy the 72 bytes where register 13 points in the primary addressspace to location 1000 in the address space referred to by access register 5.copy 13r? 1000. arto(5) length(72)subcommandUse the DELETE subcommand to delete, from virtual storage, a load module thatwas loaded by the tested program, or by one of its subtasks.Use the DELETE subcommand to delete a module that was loaded above or below16MB by the tested program or by the LOAD subcommand of TEST.TEST—DELETE subcommand syntaxTEST—COPY Subcommand►►DELETEDELload_module_name►◄TEST—DELETE subcommand operandload_module_namespecifies the name of the load module to be deleted. The load name is thename (which might be an alias) by which the program is known to the systemwhen it is in virtual storage. The name must not exceed 8 characters.TEST—DELETE subcommand examplesExample 1Operation: Delete a load module from virtual storage.Known:v The name of the load module: TOTALdelete totalordeltotalTEST—DROPsubcommandUse the DROP subcommand to remove symbols from the symbol table of themodule being tested. You can only remove symbols that you established with theEQUATE subcommand or the EQUATE operand of the GETMAIN subcommand.You cannot remove symbols that were established by the linkage editor. If theprogram being tested was assembled with the TEST option and the EQUATEsubcommand was used to override the location and type of the symbol within theprogram, then when the DROP subcommand is used to delete that symbol from thesymbol table, the symbol will reflect the original location and type within theprogram.TEST—DROP subcommand syntaxChapter 1. TSO/E commands and subcommands 305