Grundoram Manual (PDF 1.7MB) - TT Technologies Inc.

H. Mini-Atlas Assembly1. Replace the piston slide rings and the piston seals. To renew the piston sliderings and the piston seal, proceed as described in Section 9C.2. Push the piston into the casing once piston slide rings and seals have beenreplaced (see Fig. 71).3. Apply loctite to the threads on the casing end and tighten with a hammer(see Fig. 72, Fig. 73 and Fig. 74).FIG. 71: INSTALL PISTONFIG. 72: APPLY LOCTITEFIG. 73: ATTACH CASING ENDFIG. 74: TIGHTEN CASING END4. Allow 24 hours at 70° F for loctite to cure to full strength. If time does not allow,loctite can be force cured by heating to 250° F using a gas burner. After theinitial heating, secure the casing end (Item 35) again with a hammer onto aC-spanner. Keep a maximum temperature of 250° F for approximately 30minutes.NOTE: Only threaded parts firmly screwed together can transmit the full power ofthe GRUNDORAM. The adhesive prevents the thread from subsequent loosening.Do not cool with water.5. Ensure the machine has cooled down prior to being used. Do not use water tocool.TT TECHNOLOGIES, INC.35