Grundoram Manual (PDF 1.7MB) - TT Technologies Inc.

FIG. 88: PLACE CARRIER CONEON TOOLFIG. 89: INSTALL TWO RINGS INGROOVE OF TOOL BODYFIG. 90: POSITION CARRIER CONEFIG. 91: ATTACH DRAW RODS40 TT TECHNOLOGIES, INC.FIG. 92: INSTALL THRUST PIECEFIG. 93: INSTALL HYDRAULICCYLINDER8. Place carrier cone of the clamping device on the PCG GRUNDORAM tool(see Fig. 88).9. Install the two rings into the groove of the tool body (see Fig. 89).10. Position the carrier cone on top the the two rings (see Fig. 90).11. Attach the three draw rods by screwing them into the carrier cone (see Fig. 91).12. Slide the clamping plate onto the three draw rods, screw the nuts evenly ontothe draw rods to ensure the clamping plate is parallel to the end of the machinebody. Install the thrust piece (see Fig. 92).