Section 05: Automatic Tool Changers - FadalCNC.com

FadalMaintenance Manual9) Install Geneva gear on replacement motor at same position as on oldmotor.10) Place motor in ATC and slide it firmly toward the Head.11) Tighten motor mounting bolts.12) Connect ground wire and Molex connector.13) Perform alignment procedures.14) Replace the covers.Replacing the TurretMotor on a ServoTurret ATC1) Remove the ATC cover.2) Remove the motor cover.3) Disconnect both the encoder and the motor Molex connectors.4) Remove the four motor mounting bolts.5) Remove the belt from the pulley and remove the motor.6) Place the replacement motor (MTR-0144) in mount and replace the belt.7) Install the four mounting bolts.8) Pull motor upward so the belt is snug and tighten the mounting bolts.9) Connect the encoder and motor connectors.10) Perform alignment procedures.11) Replace covers.Replacing the SlideMotor1) Remover the ATC cover.2) Remove the large tension spring.3) Disconnect the Molex connector for the slide motor.4) Loosen the four motor mount bolts so motor can move to release belttension.5) Remove the belt.6) Remove the three large bolts holding the slide motor mounting plate.7) Pull the motor mounting plate up and lay it on it’s side.March 2003 Section 05: Automatic Tool Changers 127