DocuPrint P255 dw User Manual - Fuji Xerox Printers

Power Saver ModeThe printer has a power saving feature that reduces power consumption during periods of inactivityand operates in two modes: Low Power and Sleep. In Low Power mode, only the LCD panel goesblank. In Sleep mode, all LEDs, except for the (Energy Saver) LED, on the operator panel go outand the LCD panel goes blank. When the printer is in Sleep mode, it consumes less power than inLow Power mode.By default, the printer enters Low Power mode in one minute of inactivity after completion of the lastprint job, and then enters Sleep mode in another six minutes of inactivity. You can change thesedefault settings in the following ranges:Low Power mode: 1 to 30 minutesSleep mode: 6 to 11 minutesSee also:• "Changing the Power Saver Mode Settings" on page 187• Exiting the Power Saver ModeThe printer automatically exits the power saver mode when it receives a print job from a computer.Alternatively, you can manually bring it back to the ready-to-print state by pressing the (EnergySaver) button. Whether the printer is in Low Power or Sleep mode, it will take about 25 seconds forthe printer to resume the ready-to-print state.NOTE:• In Low Power mode, opening and closing the rear cover will bring the printer back to the ready-to-print state.• When the printer is in Sleep mode, all buttons on the operator panel except for the (Energy Saver) buttondo not function. To use the buttons on the operator panel, press the (Energy Saver) button to exit thepower saver mode.See also:• "Changing the Power Saver Mode Settings" on page 187Basic Operation 37