You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
TRACK BIFOLD OUTSIDE MOUNT cont.<br />
8. For OPUS, attach the metal headboard support bracket to the rear of the mounting block.<br />
9. Make necessary adjustments to ensure box out frame is level.<br />
10. Drive headboard fixing screws in all the way.<br />
11. Mount the light block lengths supplied to the rear inside edge of the sideboards (or use<br />
angle brackets instead of light block if preferred).<br />
12. Screw through the light block into the wall or architrave to attach the sideboards.<br />
13. Fit the bottom pivot plate. Measure from the front of the headboard to the centre of the<br />
top track and position the bottom pivot the same distance in, using sideboard as<br />
reference point in the absence of bottom board.<br />
23. If no bottom board supplied, attach bottom tracks by measuring the distance from the<br />
edge of headboard to centre of each track and position the bottom tracks the same<br />
distance. Use the supplied double-sided tape to fix tracks in place direct to the floor.<br />
Ensure the track fits between pivot(s). (Does not apply to bottom board as track is<br />
recessed).<br />
14. Check all necessary hardware/componentry is fitted into the top track and panels.<br />
15. Fit panels working from the pivot side toward the centre of the opening. Locate the first<br />
pair with the pivot panel and attach this into the bottom pivot bracket.<br />
16. The top pivot will already be attached to the panel, so spring load this into the top pivot<br />
bracket located in the top track.<br />
17. The next panel will have a wheel carrier bracket. Attach this to the wheel carrier in the<br />
top and lock it in place. Compress the bottom guide and release into place in the bottom<br />
track.<br />
18. If you have more than two panels stacking in one direction, sit the next pair beside the<br />
first, line the hinges up and insert hinge pins to attach then attach wheel carriers as above.<br />
19. Repeat as required.<br />
20. Make any necessary adjustments at the wheel carriers and pivot bracket to ensure panels<br />
are squared up and they operate correctly.<br />
21. Attach returns to fascia if applicable using L brackets.<br />
22. Attach L brackets to front edge of headboard according the diagrams below.<br />
23. Position fascia 50mm above headboard then screw into bracket at rear of fascia.<br />
OPUS OUTSIDE MOUNT<br />
ENCORE OUTSIDE MOUNT<br />
Attach L Bracket to top face of<br />
headboard & screw into fascia<br />
Attach L Bracket to top face of<br />
headboard & screw into fascia<br />
50mm<br />
50mm<br />
60