Multicam 11.01 Operation Manual - EVS

Issue
11.01.C
4. Remote Panel Operations
4.1 Operations
4.1.1 RECORD
4.1.2 MARK
14
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – April 2012
This key lights red when the system is recording. Pressing this key brings the system in
E/E (“live”) mode, and starts the record if necessary (depending on the settings of the
Setup menu). The E/E mode is actually playing pictures already recorded by the system,
and has a delay of 3 frames compared to the live source, on all audio and video tracks.
This function marks up to 256 cues that can be marked while recording or playing. The
cues are marked on the LIVE or PLAYBACK program depending on the value set in the
Setup menu. When the operator has marked 256 cues, the next one will overwrite the
oldest one.
4.1.3 LAST CUE
4.1.4 PLAY
4.1.5 IN
This function re-cues the EVS server to previous cue point relative to the current
timecode position. Each time the Last Cue button is pressed, the EVS server re-cues to
the previous cue, etc. When recalling a cue point, the cue number appears in the upper
left corner of the OSD if this option is enabled with the Cue number on OSD parameter
in the Operational Setup menu (p.1.1 F1)
This function initiates a forward motion. It can also be used to start playback of playlists
and clips (refer to PLST command).
When PgmSpd/Var Max is OFF, the default playback speed when pressing the PLAY
key is 100% for standard pictures, 33% for Super Motion pictures with a Triple Speed
camera (SD), and 50% for Super Motion pictures with a Double Speed camera (HD),.
When PgmSpd/Var Max is ON, the value defined in the Operational Setup menu for the
PGM Speed/Var max parameter (p.9.1 F3) is used.
This function defines the IN point of a clip. The key will light differently depending on the
following situations:
Green key The key lights green if an IN point exists but is not the image you see.
Red key The key lights red if the on-air image is at this IN point. This point can