Multicam 11.01 Operation Manual - EVS

Issue
11.01.C
28
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – April 2012
The Post-Roll mode works as follows depending on the element played:
• When a clip is played, it will not stop on the Short OUT point, but will continue to play
through the Short OUT point by the Post-Roll duration defined in the Setup Menu.
• When a record train is played, the same will happen if the Record trains OUTs
parameter is set to “Freeze” in the Operational Setup menu (p.2.3 F1).
• When a playlist is played, the Post-Roll will apply only to the last clip of the playlist.
Sort->TC
This function allows the operator to search for all clips that contain a particular timecode.
For more information on this function, refer to the section ‘Sort->TC’, on page 47.
Search
This function allows the operator to search the database using keywords and ranking.
Refer to the chapter 10 “Keyword Management” on page 71 for further details.
To return to the operational menu, press the MENU key from the Remote Panel.
6.1.2 Operational Menu
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C Cam D
CAM A/ B /C /D
If PRV CTL is OFF, select the camera to assign to the PGM output. This camera key will
be highlighted in the menu.
If PRV CTL is ON, select the camera to assign to the PRV output. This camera key will
be highlighted in the menu.
Note
In 5CAM configuration (5 recorder channels and 1 player channel) or when
loading a clip where CAM E or F exists, the operational menu will display:
Rst Cam Local Sync Prv 2nd CTRL
Cam A Cam B Cam C --->