Sony SLT-A33 - SLT-A33 Consignes d’utilisation Anglais
Sony SLT-A33 - SLT-A33 Consignes d’utilisation Anglais
Sony SLT-A33 - SLT-A33 Consignes d’utilisation Anglais
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Cleaning the image sensor<br />
If dust or debris enters the camera and lands on the image sensor (the part<br />
that acts as the film), it may appear on the photo image, depending on the<br />
shooting environment. If there is dust on the image sensor, clean the image<br />
sensor following the steps below.<br />
Notes<br />
• Cleaning cannot be performed when the battery level is 50% or less.<br />
• The camera starts beeping if the battery pack becomes low during cleaning. Stop<br />
cleaning immediately and turn the camera off. The use of an AC-PW20 AC Adaptor<br />
(sold separately) is recommended.<br />
• The cleaning should be completed quickly.<br />
• Do not use a spray blower because it may scatter water droplets inside the camera<br />
body.<br />
To clean the image sensor automatically using the cleaning mode of the<br />
camera<br />
1 Confirm that the battery is fully charged (page 22).<br />
2 Press the MENU button, then<br />
select 2 with b/B on the<br />
control button.<br />
MENU button<br />
3 Select [Cleaning Mode] with v/V,<br />
then press the center of the<br />
control button.<br />
36