1 informazioni generali - Betamotor

3
ENGINE OIL AND OIL FILTER URBAN 200
A
B
Check
Keep the vehicle in an upright position.
Check the oil level through oil level sight
A when the engine is cold. The oil level
must never fall below the sight. If necessary,
top up after removing fi ller cap B.
CHECKS AND MAINTENANCE
D
C
Topping up
Only top up after checking the max level
shown on sight A.
Renewal
Always renew the oil when the engine
is hot. To avoid burns, take care not to
touch the engine and the oil.
•Replace the oil when replacing the oil
fi lter.
• Put the vehicle on its stand.
• Put a container under the engine, right
under the drain plug D.
• Unscrew fi ller plug B and drain plug D.
• Drain all the oil from the crankcase.
• Close plug D.
• Remove the oil fi lter cover after unscrewing
the three nuts C.
• Remove the oil fi lter and replace it with
a new one.
• Apply a thin fi lm of engine oil to the fi lter
cover O-ring before insertion.
• Apply a fi lm of engine oil over the fi lter
cover O-ring before fi tting it.
GB
48