1 informazioni generali - Betamotor

3
AIR FILTER
B
C
To have access to the fi lter unit A, remove
the saddle, as described in “Removal of
body parts” on page 58.
• Remove the cover B by loosening the
screw C.
• Lift the battery holder, as shown in the
fi gure,
CHECKS AND MAINTENANCE
D
A
• Release the fi lter holder D.
• Remove the fi lter unit A.
• Pull out the holder D and take out the
sponge fi lter.
• Wash it with soap and water.
• Dry the fi lter.
•Wet the fi lter with fi lter oil. Remove any
excess lubricant to prevent it from dripping.
• If necessary, also clean the inside of the fi lter
casing.
• Refi t the parts, making sure of the seal of the
rubber gasket.
Note:
If the fi lter is very dirty, fi rst wash it with a
special detergent and then with water and
shampoo.
If the fi lter is damaged, immediately replace
it.
Clean the fi lter every time the vehicle is
used off road.
A
D
WARNING:
After working on the fi lter, ensure that nothing
is left inside the fi lter casing.
GB
54