1 informazioni generali - Betamotor

• Fit the oil fi lter cover after fi tting the spring
and the O-ring, and then tighten the three
fastening nuts C.
•Fill in with the right amount of oil:
- Oil replacement 850 ml
- With fi lter replacement 950 ml
- Overhaul 1300 ml
•Close the inlet plug B again.dle for a
few minutes.
• Turn off the engine and wait for about
one minute, then check the level and top
up if needed, without exceeding the max
level shown on the window A.
Note
Renew the oil after the fi rst 1,000 km.
Subsequent renewals should be every
5,000 km 15 months, (refer to the table
on page 63). Always use the lubricants
shown on page 43.
The oil fi lter should be replaced for the fi rst
time when the oil is fi rst renewed, and subsequently
every 10,000 km (30 months).
IMPORTANT
Dispose of used oil in compliance with the
regulations in force.
3
CHECKS AND MAINTENANCE
49 GB