1 informazioni generali - Betamotor

3
CHECKS AND MAINTENANCE
Bleeding the front brake
Follow these steps to bleed the front
brake circuit:
• Remove rubber cap A from valve B.
• Remove the oil reservoir cap C.
• Insert one end of a small tube into
valve B and place the other end in a
container.
• Unscrew valve B (while pulling the lever)
and then pump by repeatedly actuating
the brake lever until oil starts fl owing
out continuously with no air bubbles.
During this operation, it is important
that the lever should not be released
completely and that the brake pump
reservoir should be continuously refi lled
to make up for the oil that is fl owing out.
• Tighten the valve and extract the tube.
• Replace the cap in gomma A.
Bleeding the rear brake
Follow these steps to bleed the rear brake
circuit:
• Remove rubber cap D.
• Remove the oil reservoir cap E.
• Insert one end of a small tube into valve
F and place the other end in a container.
• Unscrew valve F (while pulling the lever)
and then pump by repeatedly actuating
the brake lever until oil starts fl owing
out continuously with no air bubbles.
During this operation, it is important
that the lever should not be released
completely and that the brake pump
reservoir should be continuously refi lled
to make up for the oil that is fl owing out.
• Tighten the valve and extract the tube.
• Replace the cap.
E
F
D
C
B
A
GB
52