standard specification for erection tender - GAIL

Company
symbol(insert
FAT CHECK LIST
FLOW COMPUTER
Project: Ultrasonic FLOW METER BASED METERING SKID FOR GAIL
Customer: M/s GAIL INDIA LTD, New Delhi
P.O. No.: ------------------ Dtd. -----------------------
Tag No.: Stream-2
Inspection / Simulation done for CHECKED/ OBSERVED REMARKS
Volumetric Flow rate (SCMH) Ο Accepted Ο Rejected
Totaliser ( SCM) Ο Accepted Ο Rejected
Mass Flow rate (kg/ hr) Ο Accepted Ο Rejected
Energy Flow rate (Kcal/ hr) Ο Accepted Ο Rejected
Pipe Line Temperature °C Ο Accepted Ο Rejected
Pipe Line Pressure Kg/Cm2g / Bar(g) Ο Accepted Ο Rejected
Atmospheric pressure entry at site condition Ο Accepted Ο Rejected
Base Pressure/ Base Temperature entry Ο Accepted Ο Rejected
Configuration check, parameter settings Ο Accepted Ο Rejected
PID controller Analog O/P check Ο Accepted Ο Rejected
Functioning of PID loop for FCV by simulation Ο Accepted Ο Rejected
Interface data of flow computer with
Ο Accepted Ο Rejected
RTU – Measurement by Laptop
Various Units of measurement
Ο Accepted Ο Rejected
( Flow rate in MMSCMD or SCM/Hr, heating
value in Kcal/SCM, energy in MMBTU)
Flow computer o/p to SCADA by GSM modem Ο Accepted Ο Rejected
GC data input to Flow computer from Ο Accepted Ο Rejected
SCADA via GSM modem
K factors for meter error curves Ο Accepted Ο Rejected
Audit trail printout (to be attached) Ο Accepted Ο Rejected
Software for flow calculation verification Ο Accepted Ο Rejected
_____________________ _____________________ _____________________
Company Representative TPIA GAIL’s representative
Date :
FACTORY ACCEPTANCE TEST
DOCUMENT NO. REV-0
Page 18 of 28
Copyright GAIL – All rights reserved