9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

More documents

Recommendations

Info

1. LNB loop-through output 2. Common Interface for one CA module for Pay-TV cards 1) 3. LNB input 4. Optical data stream output (SPDIF/Sony Philips Digital Interface Format) for Dolby Digital AC 3 audio 5/6. Audio outputs (L/R) - cinch sockets 7. Cable guide for infra-red sensor 1 ) CA modules and Smartcards are not included with this product 12 Connection and Setup 8. Video output (composite colour) 9. HDMI connection 10. Data interface (for service/IR sensor) 11. 1 x USB 2.0 port (USB-A plugs) 12. On/off switch 2) (switch position left “On”, switch position right “Off”) 13. Power supply connection (12 V) 2 ) The unit is not fully disconnected from the mains (see the sections “Safety Instructions - Important Information” and “Periods of extended absence, thunderstorms, mains socket accessibility”) The serial number sticker for the UFS 940sw is located on the underside of the unit. The information printed on it includes the following: - the exact designation (e.g. UFS 940sw) - the part number and - the serial number of the unit. You do not need this information in order to operate the unit. If however, contrary to expectations, you need to make a claim under warranty and you do not have the packaging for the receiver to hand, you can fi nd the above information about the unit on this sticker. On Off
1. Cable guide for infra-red sensor LED in the front panel display: The LED lights up: Connection and Setup Red (lit up) Receiver is in stand-by mode Green (lit up) Receiver in operation Green (fl ashing 3 x) USB storage medium has just been connected Green (fl ashing continuously) EPG acquisition or software update in progress Connect the Sat IF input on the receiver to the satellite reception system. Use a coaxial cable with a standard F connector. If the F standard connectors have not yet been fi tted on the cables, strip the insulation from the cables as shown in the following illustration and carefully screw the F standard connectors on to the ends of the cables to form a secure attachment. When fi tting the connector, make sure that no wires from the braid are touching the inner conductor, otherwise a short circuit will occur. The quality of the reception signal depends on a good connection at this point! 13
Page 1 and 2: Operating manual Englisch UFS 940sw
Page 3 and 4: List of Contents Preface...........
Page 5 and 6: List of Contents Antenna Configurat
Page 7 and 8: Safety Instructions - Important Inf
Page 9 and 10: The power supply unit and the recei
Page 11: Reception of digital satellite TV a
Page 15 and 16: Dolby Digital system Connection and
Page 17 and 18: Connection and Setup The four screw
Page 19 and 20: Use of other screws: If because of
Page 21 and 22: Connection and Setup Required butto
Page 23 and 24: Show 4:3 event Here you can select
Page 25 and 26: Number of Satellites When selecting
Page 27 and 28: Satellite selection When selecting
Page 29 and 30: Set borders Connection and Setup Yo
Page 31 and 32: Connection and Setup Use the butto
Page 33 and 34: Confi gure satellites Press the bu
Page 35 and 36: Satellite and Position When selecti
Page 37 and 38: LNB Type (settings) Use the button
Page 39 and 40: Transmission channel Use the butto
Page 47 and 48: If you do not wish to perform a cha
Page 49 and 50: Local time offset (UTC) Connection
Page 51 and 52: General Operating Instructions Conf
Page 53 and 54: Basic Operation in TV or Radio Mode
Page 63 and 64:
Basic Operation in TV or Radio Mode
Page 65 and 66:
EPG (Electronic Programme Guide) -
Page 67 and 68:
EPG (Electronic Programme Guide) Th
Page 69 and 70:
The search function can be called u
Page 71 and 72:
Programme not in EPG: Select any pr
Page 73 and 74:
EPG (Electronic Programme Guide) Re
Page 75 and 76:
If you want to be reminded that a p
Page 77 and 78:
Editing options for the reminder fu
Page 79 and 80:
Select a channel in the selected ch
Page 81 and 82:
Use the buttons to select “Lock
Page 83 and 84:
See “Edit channels (channel lists
Page 85 and 86:
Recording Archive (Play Back/Edit R
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Edit Channel List (see section Edit
Page 95 and 96:
During the search you will see the
Page 97 and 98:
Transponder Frequency Mainmenu - Se
Page 99 and 100:
After calling up the menu you will
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Mainmenu - Settings Always follow t
Page 109 and 110:
Mainmenu - Settings Information for
Page 111 and 112:
Page 113 and 114:
Mainmenu - Service Menu A pre-requi
Page 115 and 116:
Page 117 and 118:
Use the buttons to select “Manag
Page 119 and 120:
In the event of a malfunction, fi r
Page 121 and 122:
Connections Technical Appendix Sat
Page 123 and 124:
Sat IF Sat IF Sat IF Technical Appe
Page 125 and 126:
Sat IF Technical Appendix Sat IF **
Page 127 and 128:
HD - Ready This is a label created
Page 129 and 130:
Service If, despite studying this o
Page 131 and 132:
For your Notes 131
show all

9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

Create successful ePaper yourself

Delete template?

Save as template?