9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

LNB Type (settings)
Use the buttons to select the LNB type used in your system. The selections available are
“Universal” and “user-defi ned” (the selection “Wideband” is required only for single-cable feed systems
such as the UAS 481 from Kathrein).
Universal and Wideband:
No further input is required, since all necessary frequency ranges are covered by a Universal/
Wideband LNB.
user-defi ned:
If you choose not to use a Universal or Wideband LNB, you must here set the frequency ranges for
which your LNB was confi gured.
Use the buttons to select the frequency range to be changed (low, high or limit frequency).
Use the buttons or the number keys to set the exact frequency for which your LNB was
confi gured.
Test transponder
Connection and Setup
Use the buttons to select a transponder for the satellite selected above (this works only after
a new registration).
Then press the button to save the settings for the fi rst satellite.
If you wish to receive a second satellite with your reception system, use the buttons to switch to
the “Satellite and Position” line, and select the second satellite.
Then perform the settings (LNB and Test transponder) for the second satellite, in the same way as for
the fi rst satellite.
As soon as you have saved all settings for the selected number of satellites, the receiver skips back
automatically to the previous menu. The following display appears:
Now use the buttons to select “New registration”, and press the button.
37