9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

LNB Type (settings)
Here use the buttons to select the LNB type used in your system. The selections available
are “Universal” and “user-defi ned” (the selection “Wideband” is required only for single-cable feed
systems).
Universal:
No further input is required, since all necessary frequency ranges are covered by a universal LNB.
user-defi ned:
If you choose not to use a universal LNB, you must here set the frequency ranges for which your LNB
was confi gured.
Use the buttons to select the frequency range to be changed (low, high or limit frequency).
Use the buttons or the numbers buttons to set the exact frequency for which your LNB was
confi gured.
Test transponder
To check whether the settings that you have made are correct, use the buttons to move to the
“Test transponder” fi eld. Use the buttons to select the required transponder from the various
ones listed. If your settings are correct, you will see at the top right of the screen the live signal of
a channel from the currently selected transponder.
If you do not receive a signal, check your settings again and if necessary call for expert help.
You have now completed all settings for the fi rst satellite. Press the button to return to the
“Satellite Selection Menu” and perform the settings in the same way for the remaining satellites.
When you have fi nished confi guring the satellite, press the (green) button. The receiver then
automatically calls up the selection menu for the channel search. Continue the fi rst installation by selecting
“Execute Channel search”.
26
Connection and Setup