9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

More documents

Recommendations

Info

Use the buttons to select whether to replace the factory pre-programmed channel list by a pre-sorted channel list for a specifi c country (at present only a limited number of pre-sorted channel lists are available). If you prefer to use the factory pre-programmed channel list, choose “No” under “Restore Channel list”. The following display appears: Use the buttons here to select the basic settings for the video and audio output from the receiver to the TV set. For this, refer to the operating manual for your TV set and take care to select only those settings that your TV set can process. Video Output via Select the connection on the receiver to which you have connected your television. Either HDMI Format Here you can select the picture resolution that will be sent to your TV set. Either - 1080i (resolution 1920 x 1080, half-screen images) - 576p (resolution 720 x 576, full-screen images) or - 720p (resolution 1280 x 720, full-screen images) - automatically 22 Connection and Setup Press the (green) button to move to the next menu. HDMI or VIDEO TV aspect ratio Here you can select the TV picture format. Either - 4:3 or - 16:9
Show 4:3 event Here you can select the type of screen display mode for 4:3 broadcasts on a 16:9 TV set: - normal (Pillarbox) - stretched (Full Screen) or - zoom in (Pan & Scan) Audio format via HDMI Here you can select the type of audio signal that is transmitted by the HDMI interface. Select the signal that your TV set can process: - Decoded PCM or - S/PDIF format TV standby via HDMI If you select “Off”, the TV set must be switched on or off separately. If you select “On”, the TV set will be switched on automatically as the receiver starts up (but only if the TV set was in stand-by mode). If the receiver is switched off into stand-by mode, the TV set will also be switched to stand-by mode. Automatically switching the TV set on/off by the receiver is available only if the TV set supports this function! Connection and Setup Press the (green) button to move to the next menu. Picture format Select the type of screen display, depending on your setting for the TV format: - TV aspect ratio “4:3”: Pan & Scan or Letterbox - TV aspect ratio “16:9”: Always 16:9 or automatic Television System Here you can select the TV standard you wish to use. - PAL or - NTSC or - MULTI 23
Page 1 and 2: Operating manual Englisch UFS 940sw
Page 3 and 4: List of Contents Preface...........
Page 5 and 6: List of Contents Antenna Configurat
Page 7 and 8: Safety Instructions - Important Inf
Page 9 and 10: The power supply unit and the recei
Page 11 and 12: Reception of digital satellite TV a
Page 13 and 14: 1. Cable guide for infra-red sensor
Page 15 and 16: Dolby Digital system Connection and
Page 17 and 18: Connection and Setup The four screw
Page 19 and 20: Use of other screws: If because of
Page 21: Connection and Setup Required butto
Page 25 and 26: Number of Satellites When selecting
Page 27 and 28: Satellite selection When selecting
Page 29 and 30: Set borders Connection and Setup Yo
Page 31 and 32: Connection and Setup Use the butto
Page 33 and 34: Confi gure satellites Press the bu
Page 35 and 36: Satellite and Position When selecti
Page 37 and 38: LNB Type (settings) Use the button
Page 39 and 40: Transmission channel Use the butto
Page 47 and 48: If you do not wish to perform a cha
Page 49 and 50: Local time offset (UTC) Connection
Page 51 and 52: General Operating Instructions Conf
Page 53 and 54: Basic Operation in TV or Radio Mode
Page 65 and 66: EPG (Electronic Programme Guide) -
Page 67 and 68: EPG (Electronic Programme Guide) Th
Page 69 and 70: The search function can be called u
Page 71 and 72: Programme not in EPG: Select any pr
Page 73 and 74:
EPG (Electronic Programme Guide) Re
Page 75 and 76:
If you want to be reminded that a p
Page 77 and 78:
Editing options for the reminder fu
Page 79 and 80:
Select a channel in the selected ch
Page 81 and 82:
Use the buttons to select “Lock
Page 83 and 84:
See “Edit channels (channel lists
Page 85 and 86:
Recording Archive (Play Back/Edit R
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Edit Channel List (see section Edit
Page 95 and 96:
During the search you will see the
Page 97 and 98:
Transponder Frequency Mainmenu - Se
Page 99 and 100:
After calling up the menu you will
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Mainmenu - Settings Always follow t
Page 109 and 110:
Mainmenu - Settings Information for
Page 111 and 112:
Page 113 and 114:
Mainmenu - Service Menu A pre-requi
Page 115 and 116:
Page 117 and 118:
Use the buttons to select “Manag
Page 119 and 120:
In the event of a malfunction, fi r
Page 121 and 122:
Connections Technical Appendix Sat
Page 123 and 124:
Sat IF Sat IF Sat IF Technical Appe
Page 125 and 126:
Sat IF Technical Appendix Sat IF **
Page 127 and 128:
HD - Ready This is a label created
Page 129 and 130:
Service If, despite studying this o
Page 131 and 132:
For your Notes 131
show all

9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

Create successful ePaper yourself

Delete template?

Save as template?