9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

Connection and Setup
Use the buttons to select the frequency range to be changed (low, high or limit frequency).
Use the buttons or the number keys to set the exact frequency for which your LNB was
confi gured.
Then press the button to save your LNB selection.
Stop on signal
Use the buttons to select “Stop on signal”. Use the buttons to select here whether
the motorised antenna should stop its rotary movement immediately on receipt of a signal from the
desired satellite. You can choose between “Yes” and “No”.
Rotate antenna
Use the buttons to select “Rotate antenna”. Here you can control the movements of the
motorised antenna, using the following buttons:
Start slow rotation to the West
Rotate to the West step by step
Rotate to the East step by step
Start slow rotation to the East
Set the turntable so that both of the bars “Signal-Strength” and “Signal-Quality” on the right of the
screen show the highest available percentage values. When you have reached the best available
reception signal, use the buttons to switch to “Save” and press the button. The receiver
will now save this satellite. You have now completed all settings for the fi rst satellite. Press the
button to return to the “Satellite Selection Menu” and perform the settings in the same way
for the remaining satellites.
When you have fi nished confi guring the satellite, press the (green) button. The receiver then
automatically calls up the selection menu for the channel search. Continue the fi rst installation by
selecting “Execute Channel search”.
31