9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

More documents

Recommendations

Info

The (red dot) button allows you to set a programme for recording at any time. The programme to be recorded can be selected in any of the EPG views, provided the (red dot) button appears at the bottom of the screen display. Programme appears in EPG: Select the desired programme and press the (red dot) button. The following display appears (see example screenshot on the right): Reminder function See “Reminder function (switch over to programme)” section in this section. First you must use the buttons in the “Target” line to select the connected USB storage medium. If the USB storage medium has more than one partition, you can select the chosen one here. Each partition is displayed an a separate USB storage medium. The following display appears (example): 70 EPG (Electronic Programme Guide) Before each recording, check that there is suffi cient storage space on the selected storage medium or partition (see screenshot on the right)! You should make about 8 GB storage capacity available for one hour's HD recording (depending on the contents of the images transmitted).
Programme not in EPG: Select any programme on the channel on which the desired programme is to be broadcast at a later date, and press the (red dot) button. The following display appears (example): EPG (Electronic Programme Guide) Then press the buttons to access the “Recording” line. Use the buttons to select the desired recording mode. The following recording mode options are available: once The recording will be performed once daily The recording will be performed daily at the time you specify weekly The recording will be performed once a week on the same day and at the same time user-defi ned The recording will be performed on days specifi ed by you at times specifi ed by you Series recording The selected programme will be set up by the EPG for recording every time it is broadcast (only on the selected channel). This function however requires that the EPG data is updated daily Use the cursor buttons () to select the further items and use the number keys to make the settings. When all settings have been made, press the button to save the recording settings. You can view the scheduled recordings in the timer list view of the EPG (see “Timer list” section). First you must use the buttons in the “Target” line to select the connected USB storage medium. If the USB storage medium has more than one partition, you can select the chosen one here. Each partition is displayed an a separate USB storage medium. Then press the buttons to access the “Recording” line. Use the buttons to select the desired recording mode. The following recording mode options are available: see table above (except series recording). As there is no EPG data, you must enter the data (date, start, end) <strong>manual</strong>ly. Enter the data using the cursor buttons () or the number keys. When all settings have been made, press the button to save the recording settings. You can view the scheduled recordings in the recording schedule view of the EPG (see item “Recording schedule”). 71
Page 1 and 2:
Operating manual Englisch UFS 940sw
Page 3 and 4:
List of Contents Preface...........
Page 5 and 6:
List of Contents Antenna Configurat
Page 7 and 8:
Safety Instructions - Important Inf
Page 9 and 10:
The power supply unit and the recei
Page 11 and 12:
Reception of digital satellite TV a
Page 13 and 14:
1. Cable guide for infra-red sensor
Page 15 and 16:
Dolby Digital system Connection and
Page 17 and 18:
Connection and Setup The four screw
Page 19 and 20: Use of other screws: If because of
Page 21 and 22: Connection and Setup Required butto
Page 23 and 24: Show 4:3 event Here you can select
Page 25 and 26: Number of Satellites When selecting
Page 27 and 28: Satellite selection When selecting
Page 29 and 30: Set borders Connection and Setup Yo
Page 31 and 32: Connection and Setup Use the butto
Page 33 and 34: Confi gure satellites Press the bu
Page 35 and 36: Satellite and Position When selecti
Page 37 and 38: LNB Type (settings) Use the button
Page 39 and 40: Transmission channel Use the butto
Page 47 and 48: If you do not wish to perform a cha
Page 49 and 50: Local time offset (UTC) Connection
Page 51 and 52: General Operating Instructions Conf
Page 53 and 54: Basic Operation in TV or Radio Mode
Page 65 and 66: EPG (Electronic Programme Guide) -
Page 67 and 68: EPG (Electronic Programme Guide) Th
Page 69: The search function can be called u
Page 73 and 74: EPG (Electronic Programme Guide) Re
Page 75 and 76: If you want to be reminded that a p
Page 77 and 78: Editing options for the reminder fu
Page 79 and 80: Select a channel in the selected ch
Page 81 and 82: Use the buttons to select “Lock
Page 83 and 84: See “Edit channels (channel lists
Page 85 and 86: Recording Archive (Play Back/Edit R
Page 93 and 94: Edit Channel List (see section Edit
Page 95 and 96: During the search you will see the
Page 97 and 98: Transponder Frequency Mainmenu - Se
Page 99 and 100: After calling up the menu you will
Page 107 and 108: Mainmenu - Settings Always follow t
Page 109 and 110: Mainmenu - Settings Information for
Page 113 and 114: Mainmenu - Service Menu A pre-requi
Page 117 and 118: Use the buttons to select “Manag
Page 119 and 120: In the event of a malfunction, fi r
Page 121 and 122:
Connections Technical Appendix Sat
Page 123 and 124:
Sat IF Sat IF Sat IF Technical Appe
Page 125 and 126:
Sat IF Technical Appendix Sat IF **
Page 127 and 128:
HD - Ready This is a label created
Page 129 and 130:
Service If, despite studying this o
Page 131 and 132:
For your Notes 131
show all

9363692, Operating manual HDTV Satellite receiver UFS ... - Kathrein

Create successful ePaper yourself

Delete template?

Save as template?