Hacking the Xbox

Chapter 1 - Voiding the Warranty 23
Figure 1-2: Location of the Xbox case screws. This is a view of the bottom of
the Xbox.
Figure 1-3: Use a small flathead screwdriver to pry up an edge of the Xbox’s
rubber feet, then carefully peel them back.
In order to locate them, rub a finger firmly over the general region where
the screws should be. The label will indent slightly over the screw holes.
Puncture the label with the bit and slide or rotate the bit around until it
catches in the screw hole, and proceed to remove the screw. If you care