Ponton X/P 2.3 ? Installation and Configuration Guide

Notes
Quick-Starting the Software
When sending your activation request by e-mail, it is important to copy the
complete activation request code, including the lines “----- Begin Activation
Request -----” and “----- End Activation Request -----”. This is also the case when
copying the activation code from the reply e-mail into the Install tab. Again,
please be sure to include the “Begin” and “End” lines.
After installing a license key you may have to repeat
the activation process to
activate your license (depending on certain license conditions).
Define remote partners
To test your Messenger configuration, Ponton Consulting offers a test server
called xptest.ponton-consulting.de. This server is pre-configured in your
Messenger set-up.
Before integrating with your business partners, you can start out using this test
server as your messaging partner to experiment with different functions and
configuration options, etc.
Please note, however, that your new Messenger configuration is not known to
the Ponton test server. For this reason, you only have limited options available
for exchanging messages with the Ponton test server – in particular, you can
send messages to the test server, but the replies will generally indicate that the
sender was “unknown”.
If your tests with the xptest server are successful, you can go ahead and create
external partner settings for your business partners. The procedure is the same
Ponton X/P 2.3 – Installation and Configuration Guide 19