Ponton X/P 2.3 ? Installation and Configuration Guide

More documents

Recommendations

Info

Outbound connection Configuration Options This connection is used for e-mail messages sent by your Messenger to your business partners. The following data needs to be configured: From – the sender’s address to be used for your e-mails SMTP – the outgoing mail server to be contacted by your Messenger in order to submit the e-mail Username / password – must be entered if your mail server requires authentication for outgoing e-mails, in this case enter the settings to be used by the Messenger to log in on the mail server To test the e-mail connection, enter a receiver e-mail address (in the Send test mail to field) and click on Test. Certificate This tab is used to request and install an S/MIME certificate for your Messenger, allowing you to exchange messages via e-mail. Fill in the request form and submit your request to the Ponton CA. When you receive the S/MIME certificate go to the Show/Install tab and paste it in the entry box. Note: This is the S/MIME certificate for your local Messenger configuration. For information on requesting and installing S/MIME certificates for your remote partner Ponton X/P 2.3 – Installation and Configuration Guide 32
Configuration Options configurations please refer to the Transport Certificates section. Further details on requesting and installing certificates can be found in the Partner Certificates section. Ponton X/P 2.3 – Installation and Configuration Guide 33
Page 1 and 2: Messenger Installation and Configur
Page 3 and 4: 6.6 CONTENT RULES .................
Page 5 and 6: 1 Introduction 1.1 About Ponton X/P
Page 7 and 8: Introduction Synchronous or asynchr
Page 9 and 10: 3 Installing Ponton X/P 2.3 3.1 Min
Page 11 and 12: Installing Ponton X/P 2.3 Installat
Page 13 and 14: Quick-Starting the Software Note: S
Page 15 and 16: Quick-Starting the Software Configu
Page 17 and 18: Quick-Starting the Software If you
Page 19 and 20: Notes Quick-Starting the Software
Page 21 and 22: Quick-Starting the Software In any
Page 23 and 24: Call up the Test Adapter from the m
Page 25 and 26: Quick-Starting the Software To chec
Page 27 and 28: Configuration Options above. You ca
Page 29 and 30: Message Queue Scan Interval Configu
Page 31: E-mail Configuration By setting up
Page 35 and 36: For defining subject elements you c
Page 37 and 38: Configuration Options When you rece
Page 39 and 40: Configuration Options The Archive F
Page 41 and 42: Configuration Options You can also
Page 43 and 44: Configuration Options Finally, clic
Page 45 and 46: Configuration Options Ponton X/P 2.
Page 47 and 48: Configuration Options Note: Please
Page 51 and 52: Transport Certificates Transport ce
Page 53 and 54: Configuration Options This leads yo
Page 55 and 56: Communication Configuratio
Page 59 and 60: Configuration Options Each HFA regi
Page 61 and 62: Configuration Options If you activa
Page 63 and 64: 5.7 User Administration Two types o
Page 65 and 66: Advanced Configuration You can add
Page 67 and 68: Advanced Configuration Further, a m
Page 69 and 70: Advanced Configuration When the Lis
Page 71 and 72: Advanced Configuration \ - escape c
Page 73: Tomcat Settings Advanced Configurat

Ponton X/P 2.3 ? Installation and Configuration Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?