Manual TCIP 603-03 TCIP SRV 603-0 - Siedle

Manual TCIP 603-03
3.3. Menu tree and functionality
In the following, all the menu points and their functions are described.
3.3.1. Hardware/system
This point encompasses all the functions which affect the hardware or software.
The inputs, outputs and reader are dynamically managed. In total, 24 input modules such as code lock modules, Easikey
modules or fingerprint modules are supported. In addition to this are also the „local“ inputs and outputs on the
TCIP 603-... and the extensions FSM 740-... and SCE 640-...
3.3.1.1. Inputs
The „Hardware/System -> Inputs“ menu point provides a list of all configured inputs. A difference is drawn between
„local“ and „external“ inputs.
The „local“ inputs (inputs E1–E5) are located at the TCIP 603-01. „External“ inputs are addressed via the
FSM 740-... and SCE 640-... . If no FSM 740-... is found on startup (Power ON) of the TCIP 603-..., this function is disabled.
Fig. 4: List of inputs
Column name Description
Name This column describes the name of the input.
Door name If the input is assigned to a door, the door name appears here.
Type There are two different input types (door sensor and door button). One of these two is displayed
here when the input is in use.
Port Here, the port number of an input is displayed.
Location A distinction is made between two different locations. The location „local“ stands for local
inputs E1–E4. „Vario bus“ stands for external inputs via the FSM 740-...
Table 2: List of inputs: Column description
Two actions „Change“ and „Remove“ are assigned to each configured input. Using „Change“ the name of the input and
the device number can be changed. The action „Remove“ removes the input.
However, these actions are subject to a number of restrictions:
• If an input is assigned to a door, this can no longer be changed or removed.
• Local inputs cannot be removed.
A new external input can be created using the action „New“.
10