RK06/RK07 Disk Drive User's Manual - Trailing-Edge
RK06/RK07 Disk Drive User's Manual - Trailing-Edge
RK06/RK07 Disk Drive User's Manual - Trailing-Edge
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
10. For the last drive, connect a drive bus terminator (PN-70-12293-0-0) to I/O 12 (Figure 4-7).<br />
NOTE<br />
For the dual-controller cabling configuration (Figure<br />
4-7), the installation of the drive bus cable should follow<br />
the above sequence. The drive connectors used<br />
are J3 (8 IN) and J4 (8 OUT). A second drive bus<br />
terminator (PN-70-12293-0-0) must be connected to<br />
J4 (8 OUT) of the last drive. The second controller<br />
may be mounted in the same expander box as the<br />
first or in another cabinet altogether. If the same box<br />
is used, a second transition connector is mounted in<br />
the cabinet to accommodate the second drive bus<br />
cable.<br />
11. Ensure that circuit breaker CBl is OFF. Connect the power cable to a power outlet whose<br />
voltage and frequency meet the requirements of the drive model (Figure 4-6).<br />
12. Insert the proper drive-select plug into the unit select jack of the operator control panel<br />
(Figure 4-6). Table 4-5 lists the part numbers for each of the eight drives in the daisy chain<br />
configuration.<br />
Table 4-5 Unit-Select Plugs for <strong>RK06</strong>/<strong>RK07</strong> <strong>Disk</strong> <strong>Drive</strong>s<br />
Plug No. Part Number<br />
o 12-12691-0<br />
1 12-12691-1<br />
2 12-12691-2<br />
3 12-12691-3<br />
4 12-12691-4<br />
5 12-12691-5<br />
6 12-12691-6<br />
7 12-12691-7<br />
4.4 INSTALLATION CHECKS AND ADJUSTMENTS<br />
To verify performance and adjust the disk subsystem:<br />
1. Check controller power supply voltage.<br />
2. Check drive power supply voltage.<br />
3. Check head load/unload.<br />
4. Check head alignment.<br />
5. Check response to abnormal conditions.<br />
The required actions are detailed in Paragraphs 4.4.1 through 4.4.5.<br />
4-15