FTA Manual.pdf - Industrial Air

Installation
3.3 Important Points for Mounting and Mounting Place
63 9810.0156 – Rev.04 –12/01/2007
Caution! Subjects refering considerations during
mountings related with operations of heating or a tank are
below.
To prevent from water damages that will occure due
to especially water leakages in tank, convenable
precuations must be taken for mounting. Drain lines and
safety system must be suitable and checked periodically
during first start-up and operation.
Ambient where is boiler in must be dry and must not
frost (between 0° and 45°).
Operations about supplying required air to burn the
boiler and discharging waste gas must be in accordance
with CE standards and local distrubition companies that is
responsible from that region.
Place the boiler to a place such as rear balcony,
larder, hall, boiler room. If the boier is in balcony,
protect it from exterior factors. In case of settlement
to bath or laundry, beware boiler not to get wet.
Do not place the boiler to your bedroom!
Settle the boiler onto concrete base. (See page
25). Ambient where is boiler in should not be dusty and
moist.
Settle the boiler to a close place to chimney
channel. Flue, going to chimney, must follow shortest line
using minimum quantity of elbow. Do not install dump onto
pipe. Chimney height must not be over 150 times of
chimney hydraulic diameter.
Chimney outlet must be 1 m. upper than ringe of
roof. Horizontal flues must be connected to chimney with
%5 slant and length must not exceed 1/4 of chimney height
ever.
Mount the chimney connection flue with an
ascending slant towards chimney.
14 www.baymak.com.tr