Sym HD 125/200 servicemanual - Scootergrisen
Sym HD 125/200 servicemanual - Scootergrisen
Sym HD 125/200 servicemanual - Scootergrisen
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Clutch weight Replacement<br />
Remove snap ring and washer, and then remove<br />
clutch weight and spring from driving plate.<br />
Caution<br />
Some of models are equipped with one mounting<br />
plate instead of 3 snap rings.<br />
Check if spring is damage or insufficient elasticity.<br />
Check if shock absorption rubber is damage or<br />
deformation. Replace it if necessary.<br />
Apply with grease onto setting pins.<br />
Install new clutch weight onto setting pin and then<br />
push to the specified location.<br />
Apply with grease onto setting pins.<br />
But, the clutch block should not be greased. If so,<br />
replace it.<br />
Caution<br />
Grease or lubricant will damage the clutch weight<br />
and effect the block’s connection capacity.<br />
Install the spring into groove with pliers.<br />
To this chapter contents<br />
8. V-BELT DRIVING SYSTEM/KICK STARTER<br />
Spring Driving plate<br />
Clutch weight<br />
Shock absorption rubber<br />
Shock absorption rubber<br />
Clutch weight<br />
Spring<br />
Snap ring<br />
Setting pin<br />
8-11