Sym HD 125/200 servicemanual - Scootergrisen
Sym HD 125/200 servicemanual - Scootergrisen
Sym HD 125/200 servicemanual - Scootergrisen
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Install brake lining<br />
Apply with a thin coat of grease to the brake cam<br />
and the anchor pin.<br />
Install brake cam.<br />
Never allow brake linings to be contaminated by<br />
oil or grease.<br />
Wipe off the excessive grease from brake cam<br />
and the anchor pin.<br />
Caution<br />
Brake efficiency will be reduced if brake linings<br />
is contaminated by oil or grease.<br />
Rear brake panel<br />
Apply a thin cost of grease between the oil seals<br />
on the brake cam shaft.<br />
Install the brake cam and arm after aligning it with<br />
the punched point.<br />
Tighten the bolts and nuts to specified torque:<br />
Torque value: 0.5~0.6kgf-m<br />
Hook on the return spring.<br />
To this chapter contents<br />
Brake arm<br />
Bolt<br />
Spring<br />
Return spring<br />
Brake arm<br />
14. BRAKE<br />
O-ring<br />
Brake cam<br />
Lock pin<br />
Brake lining<br />
Brake cam<br />
Brake cam<br />
14-13
Change language