Sym HD 125/200 servicemanual - Scootergrisen
Sym HD 125/200 servicemanual - Scootergrisen
Sym HD 125/200 servicemanual - Scootergrisen
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4. FUEL SYSTEM<br />
Float Chamber<br />
Disassembly<br />
Remove 3 mounting screws and remove float<br />
chamber cover.<br />
Remove the float pin and float.<br />
Checking<br />
Check float valve and valve seat for damage,<br />
blocking.<br />
Check float valve for wearing, and check valve<br />
seat face for wear, dirt.<br />
Caution<br />
In case of worn out or dirt, the float valve and<br />
valve seat will not tightly close causing fuel level<br />
to increase and as a result, fuel flooding. A worn<br />
out or dirty float valve must be replaced with a<br />
new a new one.<br />
Remove main jet, fuel needle jet holder, needle jet,<br />
slow jet, pilot screw.<br />
Caution<br />
Take care not to damage jets and adjust screw.<br />
Before removing adjustment screw, turn it all<br />
the way down and note the number of turns.<br />
Do not turn adjust screw forcefully to avoid<br />
damaging valve seat face.<br />
Clean jets with cleaning fluid. Then use<br />
compressed air to blow the dirt off.<br />
Blow carburetor body passages with compressed<br />
air.<br />
4-8<br />
To this chapter contents<br />
Float<br />
Float Pin<br />
Needle jet<br />
Needle jet holder<br />
Main jet<br />
Pin<br />
Needle jet<br />
1 Screw<br />
Float valve<br />
Slow jet<br />
Slow jet<br />
3 Screws
Change language