8.3.17.0 - Force10 Networks

Adding an Interface to an Untagged VLAN
To move an untagged interfaces from the default VLAN to another VLAN, use the vlan untagged command
as shown in Figure 10-10.
Figure 10-10. Moving an Untagged Interface to Another VLAN
FTOS(conf)# interface tengigabit 0/16
Enter the vlan untagged command to add interface Te 0/16
FTOS(conf-if-te-0/16)# vlan untagged 4
as an untagged member of VLAN 4.
FTOS(conf-if-te-0/16)# exit
FTOS(conf)# exit
FTOS#00:23:49: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from console
Enter the show vlan command to verify that interface Te 0/16
FTOS# show vlan id 4
is an untagged member of VLAN 4.
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary,
C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged, C - CMC tagged
NUM Status Description Q Ports
4 Active U Po1(Te 0/16)
T Po128(Te 0/33,39,51,56)
T Te 0/1-15,17-32
FTOS#
Port Channel Interfaces
On an Aggregator, port channels are auto-configured as follows:
• All 10GbE uplink interfaces (ports 33 to 56) are auto-configured to belong to the same 10GbE port
channel (LAG 128).
• Server-facing interfaces (ports 1 to 32) auto-configure in LAGs (1 to 127) according to the NIC
teaming configuration on the connected servers.
Port channel interfaces support link aggregation, as described in IEEE Standard 802.3ad. .
Note: A port channel may also be referred to as a link aggregation group (LAG).
Interfaces | 129