8.3.17.0 - Force10 Networks

www.dell.com | support.dell.com
Verifying DCB Configuration
Use the show commands in Table 6-2 to display DCB configurations and statistics.
Table 6-2. Displaying DCB Configurations
Command Output
show dcb [stack-unit unit-number] (Figure 6-5) Displays data center bridging status, number of PFC-enabled ports, and
number of PFC-enabled queues. On the master switch in a stack, you can
specify a stack-unit number. Valid values: 0 to 5.
show interface port-type slot/port pfc statistics
(Figure 6-6)
show interface port-type slot/port pfc {summary
| detail} (Figure 6-7)
show interface port-type slot/port ets {summary
| detail} (Figure 6-8 and Figure 6-9)
Figure 6-5. show dcb Command Example
FTOS# show dcb
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)
Figure 6-6. show interface pfc statistics Command Example
FTOS#show interfaces te 0/0 pfc statistics
Interface TenGigabitEthernet 0/0
Priority Received PFC Frames Transmitted PFC Frames
-------- ------------------- ----------------------
0 0 0
1 0 0
2 0 0
3 0 0
4 0 0
5 0 0
6 0 0
7 0 0
68 | Data Center Bridging (DCB)
Displays counters for the PFC frames received and transmitted (by dot1p
priority class) on an interface.
Displays the PFC configuration applied to ingress traffic on an interface,
including priorities and link delay.
To clear PFC TLV counters on all ports or a specified port, use the clear pfc
counters {stack-unit unit-number | tengigabitethernet slot/port} command.
Displays the ETS configuration applied to egress traffic on an interface,
including priority groups with priorities and bandwidth allocation.
To clear ETS TLV counters on all ports or a specified port, enter the clear
ets counters stack-unit unit-number command.