8.3.17.0 - Force10 Networks

www.dell.com | support.dell.com
22 | Getting Started
Figure 4-2. Port Numbering on an Aggregator
2-Port 40-GbE QSFP+ FlexIO
Module (4x10GbE mode):
Ports 53 to 56 (top port)
Ports 49 to 52 (bottom port)
2-Port 40-GbE QSFP+ FlexIO
Module (4x10GbE mode):
Ports 45 to 48 (top port)
Ports 41 to 44(bottom port)
Console access
The Aggregator has two management ports available for system access: a serial console port and an
out-of-bounds (OOB) port.
Serial Console
A universal serial bus (USB) (A-Type) connector is located on the front panel. The USB can be defined as
an External Serial Console (RS-232) port, and is labeled on the Aggregator. The USB is on the lower side
of an installed Aggregator, as you face the I/O side of the M1000e chassis (Figure 4-1). For the console
port piMnout, refer to Table 4-1.
To access the console port, follow these steps.
Step Task
1 Connect the USB connector to the front panel. Use the RS-232 Serial Line cable to connect the Aggregator
console port to a terminal server.
2 Connect the other end of the cable to the DTE terminal server.
4-Port 10-GbE SFP+ or
4-Port 10GBASE-T FlexIO Module:
Ports 49 to 52 (4x10GbE mode)
4-Port 10-GbE SFP+ or
4-Port 10GBASE-T FlexIO Module:
Ports 41 to 44 (4x10GbE mode)
40GbE QSFP+ Port 37 (stacking)
or
Ports 37 to 40 (4x10GbE mode)
40GbE QSFP+ Port 33 (stacking)
or
Ports 33 to 36 (4x10GbE mode)