8.3.17.0 - Force10 Networks

www.dell.com | support.dell.com
Command Syntax Command Mode Purpose
monitor interface interface EXEC Privilege View interface statistics. Enter the type of interface and slot/
port information:
• For a 1GbE interface, enter the keyword GigabitEthernet
followed by the slot/port numbers; for example, interface
tengigabitethernet 0/12.
• For a 10GbE interface, enter the keyword
TenGigabitEthernet followed by the slot/port numbers;
for example, interface tengigabitethernet 0/44.
136 | Interfaces
The information displays in a continuous run, refreshes every two seconds by default (Figure 10-18). Use
the following keys to manage the output.
m - Change mode c - Clear screen
l - Page up a - Page down
T - Increase refresh interval (by 1 second)
q - Quit
t - Decrease refresh interval (by 1 second)
Figure 10-18. monitor interface Command Example
FTOS#monitor interface tengig 3/1
Dell Force10 uptime is 1 day(s), 4 hour(s), 31 minute(s)
Monitor time: 00:00:00 Refresh Intvl.: 2s
Interface: TenGig 3/1, Disabled, Link is Down, Linespeed is 1000 Mbit
Traffic statistics: Current Rate Delta
Input bytes: 0 0 Bps 0
Output bytes: 0 0 Bps 0
Input packets: 0 0 pps 0
Output packets: 0 0 pps 0
64B packets: 0 0 pps 0
Over 64B packets: 0 0 pps 0
Over 127B packets: 0 0 pps 0
Over 255B packets: 0 0 pps 0
Over 511B packets: 0 0 pps 0
Over 1023B packets: 0 0 pps 0
Error statistics:
Input underruns: 0 0 pps 0
Input giants: 0 0 pps 0
Input throttles: 0 0 pps 0
Input CRC: 0 0 pps 0
Input IP checksum: 0 0 pps 0
Input overrun: 0 0 pps 0
Output underruns: 0 0 pps 0
Output throttles: 0 0 pps 0
m - Change mode c - Clear screen
l - Page up a - Page down
T - Increase refresh interval t - Decrease refresh interval
q - Quit