8.3.17.0 - Force10 Networks

Configuring a UNIX Logging Facility Level
You can save system log messages with a UNIX system logging facility.
To configure a UNIX logging facility level, use the following command in CONFIGURATION mode:
Command Syntax Command Mode Purpose
logging facility [facility-type] CONFIGURATION Specify one of the following parameters.
• auth (for authorization messages)
• cron (for system scheduler messages)
• daemon (for system daemons)
• kern (for kernel messages)
• local0 (for local use)
• local1 (for local use)
• local2 (for local use)
• local3 (for local use)
• local4 (for local use)
• local5 (for local use)
• local6 (for local use)
• local7 (for local use). This is the default.
• lpr (for line printer system messages)
• mail (for mail system messages)
• news (for USENET news messages)
• sys9 (system use)
• sys10 (system use)
• sys11 (system use)
• sys12 (system use)
• sys13 (system use)
• sys14 (system use)
• syslog (for syslog messages)
• user (for user programs)
• uucp (UNIX to UNIX copy protocol)
The default is local7.
To view non-default settings, use the show running-config logging command (Figure 4-3) in EXEC mode.
Figure 5-2. show running-config logging Command Example
FTOS#show running-config logging
!
service timestamps log datetime
!
logging 172.16.1.162
logging 10.10.10.4
logging 10.1.2.4
logging 172.31.1.4
logging 133.33.33.4
FTOS#
Aggregator Management | 43