Edwards iH Dry Pumping Systems, iH80, iH600, iH1000

8.4 Ordering accessories
Note:
All of the accessories in Section 8.4.1 to 8.4.4 must be ordered when you order your iH system.
The accessories you have ordered will be supplied fitted to your iH system.
8.4.1 Exhaust Temperature Sensor
The Exhaust Temperature Sensor monitors the temperature in the iH exhaust outlet. When
fitted, the output of the Sensor is monitored by the iH system. If required, you can configure
the iH system to generate a warning if the exhaust temperature is too low or too high.
Accessory
Exhaust Temperature Sensor
Item Number
A532-07-000
8.4.2Active Gauge Connection Kit
The Active Gauge Connection Kit allows the iH system to monitor the pressure measured by
an Active Gauge fitted in the inlet pipeline to the iH system. Note that the Active Gauge
Connection Kit cannot be fitted if you have ordered an iH Pressure Control Kit: see Section
8.4.3.
The Connection Kit is suitable for use with any of the following BOC Edwards Active
Gauges:
• ATC-M Active Thermocouple Gauge
• ASG (1000 mbar) Active Strain Gauge
• APG-MP Active Pirani Gauge
• APG-L Active Pirani Gauge (Heated)
• Barocel Capacitance Manometers (10 to 1000 mbar or torr).
When supplied, the Active Gauge Connection Kit is configured for use with an APG-MP
Active Pirani Gauge. You will need to fit an iH PC Interface Kit if you want to reconfigure
the iH system for use with another gauge type (see Section 8.5.4).
Accessory
Active Gauge Connection Kit
Item Number
D372-41-000
8.4.3 iH600 Pressure Control Kit
The iH600 Pressure Control Kit can be fitted to an iH600 system, to enable the HCMB pump
to be automatically started at a preset inlet pressure. Note that the Active Gauge Connection
Kit accessory (see Section 8.4.2) cannot be fitted if you have ordered an iH Pressure Control
Kit.
Accessory
iH Pressure Control Kit
Item Number
A505-40-000
8-2 iH Dry Pumping Systems