Edwards iH Dry Pumping Systems, iH80, iH600, iH1000

8.5.3 iH Single Equipment Monitor and iH Fabworks
The iH Single Equipment Monitor allows you to monitor pump parameters and configure the
iH system. The iH Fabworks allows you to network together all of the iH systems in your
installation, and to use a PC to centrally monitor the iH systems. Contact your supplier or
BOC Edwards if you want to network your iH systems.
8.5.4 iH PC Interface Kits
The iH PC Interface Kit allows you to directly connect the iH system to a laptop PC or to a
desktop PC and to use the PC to switch the iH system on and off, and to monitor the status of
the iH system. The Kit is supplied with all necessary cables and with the iH Single
Equipment Monitor software.
Accessory
Desktop PC Interface Kit
Laptop PC Interface Kit (USA)
Laptop PC Interface Kit (Europe)
Laptop PC Interface Kit (UK)
Laptop PC Interface Kit (Japan)
PCMCIA Laptop PC Interface Kit
Item Number
D372-18-100
D372-18-200
D372-18-300
D372-18-400
D372-18-500
D372-17-000
8.5.5 iH Alternative Connections Kits
Use this kit to reconfigure the iH system to use the alternative nitrogen inlet and/or
cooling-water inlet and outlet connection positions (see Section 3.5).
Accessory
Alternative Nitrogen and Cooling-Water Connections Kit
Item Number
A505-34-000
8.5.6 iH Alternative Exhaust Kit
This kit provides the user with O-rings and insulation jackets to fit to the exhaust pipe in the
reversed position.
Accessory
iH Alternative Exhaust Kit
Item Number
A505-33-000
8.5.7 iH Nitrogen Flow Switch
When installed, the Flow Switch enables the iH communications Module to monitor the flow
of nitrogen purge gas to the dry pumping system, and shut down the dry pumping system if
the flow is too low.
Accessory
iH Nitrogen Flow Switch
Item Number
A532-54-000
8-4 iH Dry Pumping Systems