Medianet Reference Guide - Cisco

Cisco Network Analysis Module
Chapter 6
Medianet Management and Visibility Design Considerations
10.17.100.37 0 msec
2 10.17.100.21 4 msec
10.17.100.17 0 msec
10.17.100.21 0 msec
3 10.17.100.94 0 msec 0 msec 0 msec
4 10.17.101.10 0 msec 0 msec 0 msec
5 10.17.101.13 0 msec 4 msec 0 msec
6 10.17.1.20 0 msec 0 msec 4 msec
Figure 6-25
Test Network Used for Redundant Switch Traceroute Example
CTS-1000
10.24.1.11/24
VLAN 241
10.24.1.1/24
me-westcamp-1
10.17.100.37/30 10.17.100.42/30
me-westcore-3
me-westcore-4
10.17.100.17/30
10.17.100.21/30
10.17.100.25/30
10.17.100.29/30
Layer 3
Infrastructure
me-westcore-1
me-westcore-2
10.17.100.89/30
10.17.101.10/30
me-w-dcserv-1
me-westdc7k-1
VDC #1
VDC #2
10.17.100.94/30
me-westdc7k-2
10.17.101.13/30
me-w-dcserv-2
Layer 2
Infrastructure
me-westdc5k-1
Nexus 2000
10.17.1.20/24
me-westdc5k-2
me-westctms-1
Route #1
228436
The traceroute shown in Example 6-12 is again run from source interface VLAN 241 with source IP
address 10.24.1.11 to the Cisco TelePresence Multipoint Switch with destination IP address 10.20.1.11.
Because the switch from which the traceroute command is run has equal-cost paths to the first hop in
the path, both switches me-westdist-3 and me-westdist-4 appear as the first hop in the path. Both paths
then converge at the next switch hop, me-westcore-1, with me-westcore-2 not showing up at all in the
6-42
Medianet Reference Guide
OL-22201-01