6100CR Refrigerated Sampler - Isco

6100CR Refrigerated Sampler
Section 1 Introduction
3. If you have not previously set up the sampler’s operation or
if you want to change the setup, press the Setup key to
access the setup menus.
4. Press the Program key to select the type of sample pacing,
number of sample events, start time, etc.
5. Turn on the valve at source, calibrate the flow rate and
route the drain lines from the sampler.
6. Press the Run key to start the sampling sequence you
have programmed into the sampler. The sampler cannot
run its own program until you press Run.
7. When the sampler completes the program you entered, the
display will read:
DONE... XX SAMPLES
(time & date)
8. Press the Rack Reset key to move the rack to the home
position so you can remove the rack from the sampler.
9. Remove the filled bottle rack from the sampler.
10. Turn the unit off with the On/Off key.
11. If you want to run another sampling routine, repeat the
process from step 1.
Right (closed)
Wrong (open)
Sample bottle cap,
viewed from side
Figure 1-2 Proper Valve Orientation
1.3 Sampler Unpacking
and Setup
Teledyne Isco ships the 6100CR in a box with special inserts,
and we suggest keeping all packing materials in case returning
the unit for service ever becomes necessary. The bottle rack and
accessories are shipped separately.
1. The rack and bottles come in a mailer. You will use these
items to transport the bottle rack and also to ship the samples
to the lab for analysis. The bottle rack is shipped with
all the bottles installed and held in place under a stainless
steel cover.
1-3