6100CR Refrigerated Sampler - Isco

More documents

Recommendations

Info

6100CR Refrigerated Sampler Section 2 Programming 2-22
6100CR Refrigerated Sampler Section 3 Installation of the Sampler 3.1 Installation Guidelines Note Never install the 6100CR where there is any possibility of submersion. Water could seriously damage mechanical components inside the controller. Teledyne Isco will not honor the warranty for any 6100CR Sampler that shows evidence of submersion. Other than this, there are no serious restrictions on the installation of the sampler. You must locate the controller no further than 100 feet from the effluent pipe that is being sampled. Mount the sampler upright, in a stable location so it will not be tipped over. Route the drain hose away from the sampler far enough so the area around the base will not get wet. Avoid placing the controller in very hot locations. Make installations in a secure place so they will not be at risk from vandals or damage from any other activity going on in the area. 3.1.1 Connection of the Sample Line The sample line provided by Teledyne Isco is a 1 /4" OD polyethylene tube with an internally bonded Teflon liner to maintain sample integrity. The sample line is attached to the effluent lines by a customer-supplied valve, with appropriate coupling. The length is 25 ft. minimum to 100 ft. maximum. Note The tap into the effluent line must be a valve, rather than just a simple fitting. It is necessary to be able to turn off the flow through the sample line to service the filter periodically and for other maintenance concerns, in addition to safety concerns. CAUTION The sample tube (and its valve) are connected to an effluent pipe containing discharge that may be pressurized (as much as 120 psi); may be hot (as high as 180°F [85°C]), and will be chemically reactive, either caustic (high pH) or acidic (low pH), depending on which effluent line is being sampled. While the risk of chemical burns from either line may not be severe, the risk of heat burns from liquid this hot is very serious. Do NOT cut or shorten the sample line, even if the entire length is not needed. The 25 foot length helps remove heat from the sample. 3-1
Page 1: 6100CR Refrigerated Sampler Install
Page 5 and 6: 6100CR Refrigerated Sampler Site Re
Page 7 and 8: 6100CR Refrigerated Sampler Table o
Page 9 and 10: 6100CR Refrigerated Sampler Table o
Page 11 and 12: 6100CR Refrigerated Sampler Section
Page 45: 6100CR Refrigerated Sampler Section
Page 71 and 72: 6100CR Refrigerated Sampler Appendi
Page 73 and 74: 6100CR Refrigerated Sampler Replace
Page 75 and 76: 6100CR Refrigerated Sampler Replace
Page 87: Compliance Statements Teledyne Isco

6100CR Refrigerated Sampler - Isco

Create successful ePaper yourself

Delete template?

Save as template?